 |
 |
 |
|
Spyder Halo Projector Fog Lights for 2007 - 2010 Jeep Compass
Increase visibility and improve your vehicles appearance with a set of Spyder Halo Projector Fog Lights. Designed for direct bolt-on installation, Spyder Halo Projector Fog Lights are easy to install and a great upgrade for those looking for improved styling and enhanced illumination. Spyder Halo Projector Fog Lights are made from high quality materials to ensure durability, proper fitment, and a long lasting life span. Each set includes both left and right side fog light assemblies, a wiring harness, switch, light bulbs, and installation instructions. Spyder Halo Projector Fog Lights are SAE approved and ISO certified to meet all federal DOT regulations. Give your vehicle an upgrade in style, visibility, and appearance with a set of Spyder Halo Projector Fog Lights.
- Improved Styling & Custom Appearance
- Increased Visibility & Illumination
- Projector Style Fog Lights with Built In Halos
- Includes Two Fog Lights, Wiring Harness, Switch & Bulbs
- Direct Bolt-On Installation
- SAE Approved & ISO Certified
- Meets DOT Regulations & Safety Standards
- Limited 1 Year Manufacture Warranty
Product Application Chart
| YEAR | MAKE | MODEL | | | | | 2007 | Jeep | Compass | | 2008 | Jeep | Compass | | 2009 | Jeep | Compass | | 2010 | Jeep | Compass |
IncludesThis set of Halo Projector Fog Lights comes with two fog light assemblies (left and right), a wiring harness for installation, fog light bulbs, a switch to operate the fog lights, and detailed install instructions. All manufacture warranty information and documents will be sent with the product.
Product Notes
Spyder fog lights are compliant with federal regulations for highway use. State and local laws may vary.
Warranty Overview - Limited 1 Year Manufacture Warranty
- Protects Against All Manufacture Defects In Materials and Workmanship Under Normal Use
- Does Not Cover Damages Caused By Improper Installation, Road Hazards, Misuse, or Accidents
FL-P-DCH05-HL-SM
2007 - 2010 Jeep Compass Halo Projector Fog Lights w/Switch - Smoke
Ships From:
Manufacturer - Spyder Auto
Shipping Method:
Ground Shipping
Installation Notes:
Replacement lights should always be installed by a certified automotive technician. Typical installation procedures may include - but not limited too:
- Connect the fog light assemblies to front bumper.
- Install fog light bulbs and connect included wiring harness.
- Connect power wire to power source & ground wire to ground source.
- Connect ignition wire to ignition source (if applicable).
- Secure Relay to desirable mounting position within engine bay (if applicable).
- Run the fog light switch wiring harness through the fire wall and into the cabin.
- Secure the provided switch to a desirable location within the cabin.
- Connect the wiring harness to the switch.
- To install accessory lights (Halo's, DRL's, etc) splice the power and ground wires for the accessory lights into a power source of your choice (typically parking lights or corner lights).
- Installation procedures may vary, professional installation recommended. Detailed installation instructions will be sent with the product.
- Always be sure to test your new lights for proper fitment and function before modifying them. Modifying your parts will result in voiding the manufacturers warranty.
California Proposition 65 WarningWARNING: This product may contain chemicals and/or compounds known to the state of California to cause cancer and birth defects or other reproductive harm. For more information go to www.p65warnings.ca.gov
Manufacturer:
Spyder Auto
Manufacturer Part Number:
FL-P-DCH05-HL-SM
Product Category:
Jeep Compass Fog Lights
|
|
|
 |
|
 |
|